Epilog Laser Zing 10000 - Page 87

Section 7: Using the Epilog Dashboard
73
Why Me??!!!!
Land Lubber Award
Fewest Fish Caught!
Why Me??!!!!
Land Lubber Award
Fewest Fish Caught!
Catfish Joe
1. To make engraving the name simple, use the Center-Center feature in the
driver to quickly and accurately place a name
2. To set up your
artwork, first
measure how much
engraving space is
available on the work
piece.
a) Measure the
area (defined by
the box) so you
know how much
area is available
for engraving.
In our example
the box
measures 2
inches x .4
inches (51 mm
x 10 mm).
b) Don’t worry about the size of the whole piece. It’s not as important
for Center-Center work.
Finished piece
with engraved
name.