Section 7: Using the Epilog Dashboard
75
www.epiloglaser.com
Speed
STOP RESETGO
Pointer X/Y Off
Config
Data
Power Focus Job
0
12
3
6
7
3
4
5
89
Job:1.Sample.cdr
1. Press the X/Y OFF key on the keyboard of the laser system
2. Move the carriage by hand so that the Red Dot Pointer is at the center of the
available engraving area.
3. Once the red dot is where you want it, press the GO key. This is now your
new temporary Home position.
4. Press the RESET key.
The machine is now ready. To set the proper print parameters use the following
steps:
1. From CorelDraw select File | Print to prepare the job for printing.
2. Select Preferences to establish the laser parameters.
3. Click on the Center-Center selection and then set all other laser parameters
as you normally would.
4. Make sure to set the page size in the driver to match the page size in Corel.
5. Print the job to the laser.
To Next Page
Loading...