Section 7: Using the Epilog Dashboard
76
Job: 1.SampleFile.CDR *
Additional information about using the Center-Center feature:
The Center-Center feature is designed to be used in conjunction with the Set
Home feature of the laser system. If you do not use the Set Home feature to
create a new Home Position at the machine, the Center-Center feature will
produce a “Position Error” at the keyboard when you attempt to run the job.
When a Center-Center job has been sent to the laser, the Keyboard will indicate
that it is a Center-Center job by displaying an asterisk (*) at the end of the job
name as it is displayed on the LCD.
Where you place your work in the machine is not very important when using the
Center-Center feature. Your new Home position defines where the engraving will
take place, but you can get a “Position Error” if your artwork is going to go
outside of your available work space.
Where you place your artwork on the Corel page is not too important. The size of
your graphic just has to be sized so that it fits within the area available for
engraving on your work piece.
To Next Page
Loading...