Section 7: Using the Epilog Dashboard
77
Example #2: Laser engraveable pens:
The Center-Center feature makes locating the name on a laser engraveable pen
very easy to do.
1. First, measure the available engraving area on the barrel of the pen. For our
example the engraving area is 2” x .375” (49 x 9.5 mm).
2. In Corel, create an area that is the same size as the available engraving area
on the pen. There are several different ways that you can establish the
engraving area in Corel:
a) draw a box to represent the engraving area
b) create a page that matches the engraving area
c) use guidelines to represent the engraving area– this is shown in our
example.
3. Size the text or
image so that it fits
nicely within the
engraving area.
To Next Page
Loading...