Section 7: Using the Epilog Dashboard
78
4. Place the work piece in the machine and activate the Red Dot Pointer. We
want to set a new Home position by moving the carriage by hand so the Red
Dot Pointer is at the center of where you want to engrave. To move the
carriage by hand and set a new Home position, use the following
instructions:
a) Press the X/Y OFF key on the keyboard of the laser system
b) Move the carriage by hand so that the Red Dot Pointer is at the center
of the available engraving area.
c) Once the red dot is where you want it, press the GO key. This is now
your new temporary Home position.
d) Press the RESET key.
The machine is now ready.
5. Print using the Center-Center option in the Dashboard.
Position the Red Dot
over the center of the
area to be engraved.
To Next Page
Loading...