Epson AcuLaser C2900N - Page 261

Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 7 Confidential
RRP1.2 TRAY EXT MAIN (PL1.1.2)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
3) Open the TRANSFER ASSY (PL6.1.7).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
4) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
5) Remove the FUSER UNIT. (RRP6.1)
6) Remove the COVER CST. (RRP1.4)
7) Remove the COVER ASSY WINDOW TNR. (RRP1.6)
8) Remove the COVER SIDE R. (RRP1.5)
9) Remove the COVER SIDE L. (RRP1.7)
10) Remove the COVER REAR. (RRP1.3)
11) Slide the TRAY EXT (PL1.1.2) backward until its edge touches the machine.
12) Release the stopper of the TRAY EXT
MAIN by depressing the center section of
the rear end of the GUIDE TRAY
(PL1.1.24), and then remove the TRAY
EXT MAIN.
12)-1
12)-2