Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 210 Confidential
12) Remove the two screws (silver, tap,
8mm) that fix the BRACKET SW (PL8.2.8)
to the printer.
Note: The MAIN SWITCH and the printer are connected with the harness, so they should not be
far apart when carrying out the work described next procedure.
13) Release the BRAKET SW from the
hook together with the MAIN SW.
14) Remove the two screws (silver, tap,
12mm) that fix the COVER INLET
(PL8.2.22) to the printer.
To Next Page
Loading...
