Epson AcuLaser C2900N - Page 465

Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 211 Confidential
15) Release the hooks of the SWITCH
POWER, remove the SWITCH POWER of
the SWITCH ASSY INLET MG SFP from
the BRACKET SW.
16) Remove the COVER INLET from the
printer, pull out the harness and SWITCH
POWER through the hole on the
printer,
and remove the
SWITCH ASSY INLET
MG SFP from the printer.
17) Release the hooks of the AC INLET,
remove the AC INLET of the SWITCH
ASSY INLET MG SFP from the COVER
INLET.