Chapter 3
Network Printing
Network Connection
Theory
M
To connect your machine in a TCP/IP network environment, you must make sure that the internal
network addresses in the machine have been set.
Note:
In many cases, you have to enter only a unique IP address. However, you may also have to enter a subnet
mask and/or a gateway (router) address, depending on your network configuration requirements.
Making the Connection
Ethernet Interface
An RJ45 connector can be used as the Ethernet interface for this machine.
When connecting your machine to an Ethernet network, the tasks you perform depend on how you
plan to set the machine’s IP (Internet Protocol) address.
AcuLaser CX16NF Reference Guide
Network Printing 42
To Next Page
Loading...
Need help?
General
