Note:
If you type an incorrect password, the following message displays: “Invalid Password” Retype the
password.
Configuring the Machine for User Mode
You automatically enter User Mode whenever you enter Web-Based EpsonNet Config. In User Mode,
you can view configuration settings but not change them.
System Page
This page allows you to view several user and machine specific item.
Device Information
Summary (shown above)
The System - Device Information - Summary window provides the following information.
Item Description
Device Name Displays the name of the machine.
Device Place Displays the setup location for the machine.
Engine Serial Number Displays the serial number of the machine engine.
Memory Displays the amount of memory installed in the machine.
Input Tray Identifies the input trays installed on the machine.
Note:
If the optional lower feeder unit has been installed, “Tray 2” is indicated.
Network Lists the machine interface (Ethernet 10Base-T/100Base-TX)
Login button Logs in of Administrator Mode.
Note:
This button is available from all web pages (User Mode).
Input Tray
The System - Device Information - Input Tray window provides the following information.
AcuLaser CX16NF Reference Guide
Using Web-Based EpsonNet Config 59
To Next Page
Loading...
Need help?
General
