About the PostScript Printer Driver 144
6. Select USB as the port the printer is connected to, then click Next.
7. Click Have Disk and specify the following path for the CD-ROM. If your CD-ROM drive is D:,
the path will be D:\ADOBEPS\ENGLISH\PS_SETUP. Then click OK.
Note:
Change the drive letter as needed for your system.
8. Select the printer, then click Next.
9. Follow the on-screen instructions for the rest of the installation.
10. When installation is done, click Finish.
Installing the PostScript printer driver for the network interface
Note:
❏ Set the network settings before installing the printer driver. Refer to the Network Guide that comes with
your printer for details.
❏ Turn off all virus protection programs before installing the printer software.
1. Make sure that the printer is turned on. Insert the printer software CD-ROM into your
CD-ROM drive.
2. For Windows Vista, Vista x64, XP, or XP x64, click Start, point to Printer and Faxes, and click
Add a printer in the Printer Tasks menu.
For Windows 2000, click Start, point to Settings, and click Printers. Then double-click the Add
Printer icon.
3. The Add Printer Wizard appears. Then click Next.
4. Select Local printer, then click Next.
Note:
Do not select the Automatically detect and install my Plug and Play printer check box.
5. Select the Create a new port check box and select Standard TCP/IP Port from the
drop-down list. Click Next.
6. Click Next.
7. Specify the IP address and port name, then click Next.
8. Click Finish.
To Next Page
Loading...
Need help?
General
