About the PostScript Printer Driver 146
For Mac OS X users
Note:
Make sure that Printer Setup Utility (for Mac OS X 10.3 and 10.4) or Print Center (for Mac OS X 10.2)
is not open.
1. Insert the printer software CD-ROM into your CD-ROM drive.
2. Double-click the CD-ROM icon.
3. Double-click Mac OS X, then double-click PS Installer.
Note:
For Mac OS X 10.2, if the Authenticate window appears, enter the user name and password for an
administrator.
4. The Install EPSON PostScript Software screen appears, click Continue, then follow the
on-screen instructions.
5. Easy Install is displayed on the screen. Click Install.
Note:
For Mac OS X 10.3 and 10.4, if the Authenticate window appears, enter the user name and password for
an administrator.
6. When installation is done, click Close.
Selecting the printer
After installing the PostScript 3 printer driver, you need to select the printer.
In a network environment
For Mac OS X users
Note:
❏ Although EPSON FireWire appears in the interface pop-up list, you cannot use FireWire for printer
connection in the PostScript 3 mode.
❏ You need to make the settings for your installed options manually when the printer is connected using
USB, IP printing, or Bonjour (Rendezvous). When the printer is connected using AppleTalk, the printer
software automatically makes the settings.
❏ Make sure to specify ASCII as the data format in the application.
To Next Page
Loading...
Need help?
General
