Epson Aculaser M2000 series User Manual

Troubleshooting 80
3. Put your finger into the hole of the outer green knob on each side of the photoconductor unit.
Then, pull the photoconductor unit towards you.
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION HOT SURFACE, or the
surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very
hot. If you must touch one of these areas, wait 30 minutes to allow the heat to subside before doing
so.

Epson Aculaser M2000 series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	20, 000 pages
Supported Operating Systems	Windows, Mac OS, Linux
Paper Capacity	250 sheets
Connectivity	USB 2.0