Item Explanation
USB I/F Allows you to activate or deactivate the USB interface.
Settings (default in bold):
On, Off
USB Speed Allows you to select the operation mode of USB interface. Selecting HS is recommended.
Select FS if HS does not work on your computer system.
Settings (default in bold):
HS, FS
Buffer Size Determines the amount of memory to be used for receiving data and printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five
seconds then turn it back on. Or, you can perform a Reset All operation, as
explained in Reset Menu.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not
flashing when you reset the printer.
Settings (default in bold):
Normal, Maximum, Minimum
Network Menu
See the Network Guide for each setting.
Note:
After any item in the menu is changed, the setting takes effect after a warm boot or after the power is turned on again. While it is
reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is turned on
again.
USB Host Menu
Note:
After any item in the menu is changed, the setting takes effect after a warm boot or after the power is turned on again. While it is
reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is turned on
again.
Item Explanation
USB Host Enables you to print directly from a USB memory via a USB Host interface.
Settings (default in bold):
On, Off
AL-C300 Series User's Guide
Getting to Know Your Printer
23
To Next Page
Loading...
Need help?
General