Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 105
Confidential
4.2.2.3 Hinge
Parts/Components need to be removed in advance:
ADF Unit (Artisan 800/PX800FW/TX800FW only)/Scanner Unit
Removal procedure
1. Remove the screw (x1) that secures the Hinge and remove the Hinge.
Figure 4-12. Removing the Hinge
4. Close the Scanner Unit.
5. Tighten the screw (x1) finally after making sure that there
is no gap between the Scanner Unit and the printer.
Figure 4-11. Installing the Scanner Unit
Make sure to insert the terminal of the Grounding wire to the
fixing rib of the Frame. (See
Fig. 4-6.)
For the routing of the FFCs, see 4.4 "Routing FFC/cables"
(p202).
When installing the Cable Cover, secure it with a new Harness
Cover Clamp. (See
Fig. 4-3.)
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Scanner Unit, make the specified
adjustments. (See
Chapter 5 "ADJUSTMENT".)
Screw (Final tightening)
Check the gap
Hinge
C.B.P. 3x10 (6±1Kgfcm)(Artisan 800/PX800FW/TX800FW)
C.B.P. 3x12 (black) (6±1Kgfcm)(Artisan 700/PX700W/TX700W)
http://www.manuals4you.com
To Next Page
Loading...
