Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 181
Confidential
4.2.6.9 ADF Motor Unit
Parts/Components need to be removed in advance:
Scanner Unit/ADF Unit/ADF Cover Assy/ADF Right Cover/ADF Rear Cover/
ADF Cover Stacker/ADF Document Support Cover/ADF Front Cover/ADF
Document Support Assy/ADF Frame Unit
Removal procedure
1. Peel off the acetate tape (x3), and separate the ADF Motor cable, the ADF
Sensor cable and the Grounding Wire.
2. Release the hooks (x4) of the ADF Cable Cover and open the ADF Cable
Cover, then release the ADF Motor cable, the ADF Sensor cable and the
Grounding Wire.
Figure 4-193. Releasing the cables
3. Remove the screws (x2) that secure the ADF Motor Unit.
Figure 4-195. Removing the ADF Motor Unit (1)
ADF Cable Cover
Hook
Acetate tapes (x2)
Acetate tape
ADF Sensor cable
Grounding Wire
ADF Motor cable
When removing the ADF Motor Unit, be careful not to drop the
gears (x5) of the ADF Frame Unit and ADF Motor Unit shown
below.
Figure 4-194. Handling the ADF Motor Unit
ADF Frame Unit
Do not drop these.
Do not drop these.
ADF Motor Unit
C.B.P. 3x8 (6±1kgfcm)
http://www.manuals4you.com
To Next Page
Loading...
