Epson Artison 800 - Transmission Holder Assy

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 158
Confidential
4.2.4.17 Transmission Holder Assy
 Parts/Components need to be removed in advance:
Main Frame/Printhead/CR Scale/Carriage Unit/Ink System
 Removal procedure
1. Push the Switch Lever in the direction of the arrow and disengage the
Transmission Arm from the Transmission Holder Assy. (See
Fig. 4-86, Fig.
4-140.)
2. Remove the screw (x1) that secures the Transmission Holder Assy. (See Fig.
4-140.)
3. Release the PE Sensor Cable from the Transmission Holder Assy, and remove
the Transmission Holder Assy.
Figure 4-140. Removing the Transmission Holder Assy
C H E C K
P O I N T
 The Main Frame becomes unstable once it is removed from the
Base Frame. Be careful not to deform the frame during
performing the following procedures.
 Refer to 4.2.4.11 Main Frame (p144) for the Parts/Components
need to be removed before removing the Main Frame.
Switch Lever
Transmission Arm
C.B.P. 3x8 (6±1Kgfcm)
Transmission Holder Assy
PE Sensor Cable
 Make sure that all gears on the Transmission Holder Assy are
properly installed to the hooks and move smoothly.
Figure 4-141. Installing the Transmission Holder Assy (1)
 When assembling the Transmission Holder Assy, align the
hooks (x3) of the Transmission Holder Assy with the ribs (x3)
of the Main Frame.
Figure 4-142. Installing the Transmission Holder Assy (2)
 For routing the FFCs, see 4.4 "Routing FFC/cables" (p202).
Hook
Bottom side
Rib of the Main Frame
Transmission Holder Assy
Hook
http://www.manuals4you.com