Epson Artison 800 - Page 135

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 136
Confidential
4. Disconnect the AID cable from the connector on the SUB Board.(See Fig.
4-84.)
5. Remove the Ink System from the bottom of the printer.
Figure 4-84. Removing the Ink System (2)
C A U T I O N
So as to make description easier, the printer in the photographs is
placed vertically in the following steps. Be careful about ink spilling
if the printer is tilted in practical operation.
C A U T I O N
 Be careful about ink spilling from the Waste Ink Tube.
 Do not damage the Rubber Seal or the Head Cleaner on the cap
with frames or other parts. (See
Fig. 4-87.)
Ink System
Waste Ink Tube
AID cable
Connector on SUB Board
Groove on Base Frame
Bottom side
Install the Ink System as follows:
1. When the Carriage Lock sticks out, rotate the Combination
Gear in the direction of the arrow to lower the Carriage Lock.
Figure 4-85. Installing the Ink System (1)
2. Press the switch lever in the direction of the arrow and move the
Transmission Arm upward by rotating the Spur Gear to make a
room.
Figure 4-86. Installing the Ink System (2)
Carriage Lock
Ink System
Combination Gear
Transmission Arm
Transmission Arm
Spur Gear
Switch lever
Transmission Arm
http://www.manuals4you.com