Epson Artison 800 - 5.3.4 Touch Panel Adjustment

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
ADJUSTMENT Adjustment without Using Adjustment Program 242
Confidential
5.3.4 Touch Panel Adjustment (Epson Artisan 800/Epson
Stylus Photo PX800FW/TX800FW only)
This section describes Touch Panel adjustment.
 Purpose
This adjustment is made to adjust the relative positions between the Touch Panel
detection points and displaying positions on the Control Panel.
 Things to be used
Touch pen (without a sharp end such as a plastic stick)
 Adjustment procedure
1. Turn on the printer in the special inspection mode. (See 5.2.8 Case Open Sensor
Check Step1 (p226).)
2. Select “Touch Screen Inspection” and press LCD.
Figure 5-46. Touch Panel Adjustment (1)
3. Select “Touch Screen Calibration” and press LCD.
Figure 5-47. Touch Panel Adjustment (2)
4. Press LCD to display the adjustment screen. When aborting the adjustment, press
the area other than LCD.
Figure 5-48. Touch Panel Adjustment (3)
C H E C K
P O I N T
While in the special inspection mode, you can operate selection of
each menu, etc. by pressing the following areas on the touch panel.
Figure 5-45. Panel Operation in Special Inspection Mode
Power Left side of the touch panel
(Menu backward)
Right side of the touch panel
(Menu forward)
“CD/DVD tray” button LCD (OK/Menu selection)
Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1. Mechanism Inspection
2. Special Inspection
3. Fax Inspection
4. Touch Screen Inspection
5. Development Mode
Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1. Touch Screen Calibration
2. Touch Screen Coordinates
Touch panel to coordinate them
Touch LCD area. [OK]
Touch area outside of LCD. [Cancel]
http://www.manuals4you.com