Epson Artison 800 - Page 223

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
ADJUSTMENT Adjustment Using Adjustment Program 224
Confidential
 Setting procedure
1. Start the adjustment program.
2. Select the “Initial Setting” from the menu. The initial setting screen appears.
3. Enter the last six digits of MAC address into the MAC address entry field, and
click the MAC Address input button.
(Enter the address again into the second entry field to confirm it.)
4. Select the network status sheet print menu on the printer’s control panel, and print
the sheet. Check the MAC address printed on the sheet to see if it is correct. refer
to Figure 1-11 "Sample of Network Status Sheet".
Figure 5-10. MAC Address Setting Screen
C A U T I O N
 The MAC address required on the adjustment program is
written on the MAC address label on the Upper M/B Shield
Plate.
Make sure that the address written on the MAC address label
matches the MAC address settings in the EEPROM.
Figure 5-9. MAC Address Label
 Do not use the MAC address of the label attached to the
Wireless LAN Board since the address is not used for this
product.
Label, MAC address
the last six digits of MAC address
http://www.manuals4you.com