Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
TROUBLESHOOTING Network Troubleshooting 80
Confidential
Troubles during printing and scanning from PC
Table 3-30. Troubles during printing and scanning from PC
Symptom Check Point Remedy
Print cannot be made
Scan cannot be made
1. In Wireless LAN’s case, check
if the network connection
between the PC and Access
Point is made.
Correctly connect the
computer and the Access
Point.
2. In Wired LAN’s case, check if
the computer and the printer are
properly connected to a LAN
port such as a hub or router.
Correctly connect the
computer and the printer to a
LAN port such as a hub or
router using a LAN cable.
3. Check the status of network
settings/connection by printing
the network status sheet.
Correctly set the network
connection again if the
network connection is not
made.
4. Check if the link lamp on the
Access Point or hub connected
to the printer is lighting or
flashing.
• Try using another port.
• Replace the LAN cable.
• Configure Wireless LAN
setting correctly.
5. Check if the network settings
are correctly configured?
Correctly configure the
network settings.
6. Check if the network setting
screen is displayed on the
Control Panel.
Close the screen.
EPSON Scan cannot
be started
1. For EPSON Scan settings,
check if IP address is set
directly.
If IP address is set using the
DHCP function, specify IP
address by searching address.
http://www.manuals4you.com
To Next Page
Loading...
