219
Input Signal Settings - Signal Menu
Normally the projector detects and optimizes the input signal settings automatically. If you need to
customize the settings, you can use the Signal menu. The available settings depend on the currently
selected input source.
Note: You can restore the default settings of the Position, Tracking, and Sync settings by pressing the
Auto button on the remote control.
To change settings for an input source, make sure the source is connected and select that source.
Setting Options Description
Resolution Auto
Wide
Normal
Sets the input signal resolution if not
detected automatically using the Auto
option
Aspect See the list of available
aspect ratios
Sets the aspect ratio (width-to-height
ratio) for the selected input source
Tracking Varying levels available Adjusts signal to eliminate vertical stripes
in computer images
Sync. Varying levels available Adjusts signal to eliminate fuzziness or
flickering in computer images
Position Up, down, left, right Adjusts the image location on the screen
To Next Page
Loading...
