Epson BrightLink 710Ui - Solutions When You Cannot Operate a Computer from the Projected Screen; Solutions When Inking Does Not Appear in Microsoft Office; Solutions When the Pen Does Not Work over a Network or the Toolbars Do Not Appear

283
Solutions When You Cannot Operate a Computer from the Projected Screen
If you are unable to access a computer from the projected screen, try the following solutions:
• Make sure the USB Type B setting on the Extended menu is set to Easy Interactive Function or
USB Display/Easy Interactive Function.
• Make sure you perform pen calibration when using the interactive pen for the first time so that the
projector recognizes the position of the pen correctly.
• Press the Pen Mode button on the remote control to select PC Interactive as the Pen Mode setting.
You can also select the Pen Mode setting from the projector's Extended menu.
• Make sure the USB cable is securely connected. Disconnect the USB cable, and then reconnect it.
• When projecting an image using two projectors installed side-by-side, you need to select the Multi-
Projection setting in order to use the interactive features. You also need to download the Easy
Interactive Driver Ver. 4.0 and install it on the computer that you want to operate from the projected
screen.
• When projecting an image with only one of the two projectors installed side by side, you may not be
able to operate a computer from the projected screen. Select the icon on the Home screen, and
then set Use this single projector to On.
Parent topic: Solving Interactive Problems
Solutions When Inking Does Not Appear in Microsoft Office
If Start Inking does not appear on the Review tab in your Microsoft Office application, change the Pen
Operation Mode setting.
Parent topic: Solving Interactive Problems
Related references
Projector Setup Settings - Extended Menu
Solutions When the Pen Does Not Work Over a Network or the Toolbars Do Not Appear
If you are having trouble using the pen with a network connection, or the toolbars do not appear on your
projected image, try the following solutions:
• If you are using Epson iProjection (Windows/Mac) software, select Set Options and make sure Use
Interactive Pen is enabled. Also, select the Adjust performance tab and select Transfer layered
window.
Parent topic: Solving Interactive Problems