Epson Disc Producer PP-100 - Printer Tray Does Not Come out

124
Printer Tray Does not Come Out
Turn the power of the product off and then on again. If the printer tray still does not come out, perform the procedure
below.
For PP-100/PP-50
1
Turn the product off.
See “Turning Off the Power” on page 19.
2
After the Power light goes off, unplug the power plug from the outlet.
3
Remove the two screws to remove the rear printer cover.
If the disc can be removed, eject the disc and reattach the rear printer cover. If the disc cannot be removed,
proceed to the procedure below.
4
Grasp the fixture as shown in the figure below, and push the printer tray in the direction of
the arrow indicated below.