56
Selecting Publish Mode
Setting the most suitable publish mode for the usage or number of discs to be published enables efficient disc
publishing.
Select the publish mode, referring to the following descriptions, and change the setting in the properties setting if
necessary. For properties setting procedure, see “Properties Setting” on page 27.
The PP-100 and PP-100AP have three publish modes, Standard mode, External Output mode, and Batch mode.
The PP-50 has two publish modes, Low-volume mode and Standard mode.
For PP-100/PP-100AP
Standard mode: When you want to publish up to 50 identical discs at once
This mode uses Stacker 1 as the input stacker for discs. You can select Stacker 2 or Stacker 4 as the output stacker.
If you select Stacker 2 as the output stacker, you can publish up to 50 discs without having to replenish the discs or
take out published discs.
If you select Stacker 4 as the output stacker, you can easily take out published discs without even having to pause a
job during publishing up to 50 discs.
Repeatedly replenishing and taking out discs allows for the continuous publishing of up to 1,000 discs.
When you select Stacker 2 as the output stacker
When you select stacker 4 as the output stacker
If you publish with EPSON Total Disc Maker, you can change the publish mode setting in
Publish view.
To Next Page
Loading...
Need help?
General
