129
Troubleshooting
Disc Recording Surface is Stained with Ink
When the disc recording surface is stained with ink, the printer tray may be dirty. Clean the printer tray by following
the procedure below.
For PP-100/PP-50
1
Turn the product off.
See “Turning Off the Power” on page 19.
2
After the Power light goes off, unplug the power plug from the outlet.
3
Remove the two screws to remove the rear printer cover.
4
Grasp the fixture as shown in the figure below, and push the printer tray in the direction of
the arrow indicated below.
To Next Page
Loading...
