71
Publishing Discs
For PP-50
The stacker used as the output stacker differs depending on the publish mode. Confirm the output stacker in the
following table.
1
Open the disc cover.
For precautions when you open the disc cover, see “Opening the Disc Cover” on page 20.
2
Only when the output stacker is Stacker 2, take it out.
3
Take out the published discs from the output stacker.
Publish Mode Output Stacker Number of Discs
Standard mode
(when the output stacker is set to Stacker 2)
Stacker 2 Up to approximately 50 discs
Standard mode
(when the output stacker is set to Stacker 3)
Stacker 3 Up to approximately 20 discs
Low-volume mode Stacker 3 Up to approximately 20 discs
After printing on the label surface, allow EPSON specified CDs/DVDs to dry for at least
one hour, and other types of discs for at least 24 hours. Do not insert discs into a drive or
other device until they are completely dry.
Avoid drying under direct sunlight.
Directly touching or moisture getting on the label surface before or after printing may
result in blurring or discs sticking together.
<Stacker 2> <Stacker 4><Stacker 3>
To Next Page
Loading...
Need help?
General
