EasyManua.ls Logo

Epson EB-485W - Page 120

Epson EB-485W
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Status Cause Remedy or Status
If it is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s Epson Projector Contact List
If it is cracked: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be projected until
the lamp is replaced.)
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.103
Auto Iris Error
Power Err.
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
Check that the air filter and air exhaust vent are not blocked, and that the projector is not positioned against a wall.
If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.138, "Replacing the Air Filter" p.142
Replace Lamp Replace it with a new lamp.
s "Replacing the Lamp" p.139
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may blow increases. Replace it with a new
lamp as soon as possible.
Obstacle Detection Er‐
ror
A warning sound is output and the message "For safety purposes remove any obstacles blocking the lens." is displayed. The projector will turns
off automatically if no action is taken.
Remove obstacles around the projection window.
Clean the obstacle sensor if there is no obstacle.
s "Cleaning the Obstacle Sensor" p.137
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Problem Solving
120
http://www.pureglare.com.au

Table of Contents

Other manuals for Epson EB-485W

Related product manuals