Check Remedy
Is the power of the connected computer or video equipment turned
on?
Turn the power on for the equipment.
Are the image signals being output to the projector?
(Only when projecting images from a laptop computer or a
computer with a built-in LCD screen)
If the image signals are only being output to the computer's LCD monitor or accessory monitor, change the output so
that the image signals are also output externally. For some computer models, when the image signals are output
externally, they no longer appear on the LCD monitor or accessory monitor.
If the connection is made while the power of the projector or computer is already turned on, the Fn key (Function key)
that changes the computer's image signal to external output may not work. Turn the projector and computer off and then
back on again.
s "From Installation to Projection" p.39
s Computer's documentation
Images are fuzzy, out of focus, or distorted
Check Remedy
Is the focus adjusted correctly? Move the focus lever to adjust the focus.
s "Correcting the Focus" p.50
Is the projector at the correct distance? Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.
s
"Screen Size and Projection Distance" p.147
Is the Keystone adjustment value too large? Lower the projection angle to reduce the amount of Keystone correction.
s "Adjusting the Vertical Position of the Image (Models Supplied with the Feet Only)" p.49
Is the
Aspect Ratio
g
set correctly? You can change the Aspect Ratio of the projected image to suit the type, the ratio of height and width, and the resolution
of the input signals.
s "Changing the Aspect Ratio of the Projected Image" p.52
Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.
Problem Solving
125
To Next Page
Loading...
Need help?
General
Weight and Dimensions
