EasyManuals Logo

Epson EB-485W User Manual

Epson EB-485W
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
Cannot operate as a mouse and draw by connecting to a computer
Check Remedy
Is Extended set correctly? Make the following settings to link with the computer's functions.
Set Extended - USB Type B to Easy Interactive Function or USB Display/Easy Interactive Function from the
configuration menu.
Set the source where the computer is connected in Extended - Easy Interactive Function - Use Source from the
configuration menu.
s Extended - Easy Interactive Function p.103
The projector is not correctly connected to the computer. Check the USB cable connections. You may be able to resolve the problem by disconnecting and then reconnecting the
USB cable.
If you are using a notebook computer when the battery power is
running low, the USB port may stop working and you might not be
able to use USB devices.
Connect the computer to a power source.
The message "An error occurred in the Easy Interactive Function." is displayed
Check Remedy
An error has occurred in the Easy Interactive Function. Contact the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
The Easy Interactive Pen does not work
Check Remedy
There is an obstacle in the signal route between the Easy Interactive
Pen and the projector.
Remove the obstacle. Also, do not block the signal route when standing in front of the projection screen.
The signal is interfering with other things such as a light source that
is emitting infrared rays.
Do not use an infrared remote control or infrared microphone in the same room because the Easy Interactive Pen may
malfunction. Switch off the interfering device such as a light source that is emitting infrared rays.
The battery is low. Replace the battery.
The surrounding area is too bright. Do not allow strong light to shine on the projected screen or the projector's Easy Interactive Function receiver.
Problem Solving
130
http://www.pureglare.com.au

Table of Contents

Other manuals for Epson EB-485W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EB-485W and is the answer not in the manual?

Epson EB-485W Specifications

General IconGeneral
FocusManual
Offset5.8 %
Focal length range0 - 3.71 mm
Matrix size0.59 \
White light output3100 ANSI lumens
Native aspect ratio16:10
Projection distance0 - 0.43 m
Projection technology3LCD
Contrast ratio (typical)3000:1
Screen size compatibility60 - 100 \
Projector native resolutionWXGA (1280x800)
Keystone correction, horizontal-5 - 5 °
Projector brightness (economic mode)1800 ANSI lumens
Lamp typeUHE
Lamp power215 W
Light source typeLamp
Service life of light source3000 h
Service life of light source (economic mode)4000 h
Full HDNo
Analog signal format system-
USB connector typeUSB Type-A, USB Type-B
Serial interface typeRS-232
USB 2.0 ports quantity2
VGA (D-Sub) ports quantity3
Ethernet LANYes
Ethernet LAN data rates10, 100 Mbit/s
Noise level35 dB
Noise level (economic mode)28 dB
RMS rated power16 W
PlacementDesktop, Ceiling
Product typeStandard throw projector
Product colorWhite
Cable lock slot typeKensington
Power sourceAC
Power consumption (standby)0.27 W
Power consumption (typical)300 W
Weight and Dimensions IconWeight and Dimensions
Weight5200 g

Related product manuals