Mail is not received even if an error occurs with the projector
Check Remedy
Is Standby Mode set to Communication On? To use the Mail Notification function when the projector is in standby, set Communication On in Standby Mode from
the Configuration menu.
s Extended - Standby Setup - Standby Mode p.103
Did a fatal abnormality occur and the projector come to a sudden
stop?
When the projector comes to a sudden stop, email cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
s Epson Projector Contact List
Is power being supplied to the projector? Check that your electrical outlet or power source is functioning correctly.
Is the Mail Notification function set correctly in the Configuration
menu?
An error notification email is sent according to the Mail settings in the Configuration menu. Check if it is set correctly.
s "Mail menu" p.111
Image file names are not displayed correctly in Slideshow
Check Remedy
Is the file name too long? The file name can be up to 8 characters long. For file names longer than this, the middle of the name is
omitted to shorten the name to 8 characters.
Are there any 2-byte characters in the file name? Only alphanumerical characters and symbols can be used in file names. Any other characters are replaced with
a question mark (?).
Cannot change settings using a web browser
Check Remedy
Are the user ID and password correct? Enter "EPSONWEB" as the user ID. This cannot be changed. Enter the user ID even if the password setting is
disabled.
Enter the password you set in Web Control Password. The default password is "admin".
Problem Solving
134
To Next Page
Loading...
Need help?
General
Weight and Dimensions
