Crestron Connected Support
209
If you are using the Crestron Connected network monitoring and control
system, you can set up your projector for use on the system. Crestron
Connected lets you control and monitor your projector using a Web browser.
a
• You cannot use the Message Broadcasting feature in Epson Projector
Management when you use Crestron Connected.
• If you set the Standby Mode setting to Communication On in the
projector's Operation menu, you can control the projector even if
the projector is in standby mode (when the power is off).
For additional information on Crestron Connected, visit the Crestron Web
site.
https://www.crestron.com/products/line/crestron-connected
To monitor devices in the system, you can use Crestron RoomView Express
or Crestron Fusion provided by Crestron. You can communicate with the
help desk and send emergency messages. See the following Web site for
details.
http://www.crestron.com/getroomview
This manual describes how to perform operations on your computer using a
Web browser.
gg Related Links
• "Setting Up Crestron Connected Support" p.209
Setting Up Crestron Connected Support
To set up your projector for monitoring and control using a Crestron
Connected system, make sure your computer and projector are connected to
the network. If you are connecting wirelessly, connect to devices over a
wireless network access point.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Select the Projector Control menu and press [Enter].
d
Set the Crestron Connected setting to On to allow the projector to be
detected.
e
When you finish selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
f
Turn off the projector, and then turn it on again to enable the setting.
g
Start your Web browser on a computer or device connected to the
network.
h
Go to the Epson Web Control screen by entering the projector's IP
address into the browser's address box.
i
Select the Crestron Connected settings. See the Crestron Web site for
details.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
