Projector Network Settings - Network Menu
234
Setting Options Description
IP Address Display On
Off
Set to On to display the IP address on the
network information screen and Home
screen.
Network Menu - Mail Notification Menu
Settings on the Mail Notification menu let you receive an email notification if
a problem or warning occurs in the projector.
Setting Options Description
Mail Notification On
Off
Set to On to send an email to the preset
addresses when a problem or warning
occurs with a projector.
SMTP Server Various IP
addresses
Enter the IP address for the projector's
SMTP server using 0 to 255 for each
address field.
Do not use these addresses: 127.x.x.x,
192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255).
Authentication Open
Auth
SSL
TLS
Select the authentication type of the
SMTP server.
Port Number 1 to 65535 (default
is 25)
Enter a number for the SMTP server Port
Number.
User Name Up to 64
alphanumeric
characters
Enter a user name for the SMTP server.
Password Up to 64
alphanumeric
characters
Enter a password for authentication on
the SMTP server.
Setting Options Description
From Up to 64
alphanumeric
characters
(do not use " ( ) , : ;
< > [ \] spaces)
Enter the email address of the sender.
Address 1 Setting
Address 2 Setting
Address 3 Setting
Enter the e-mail address, and select the
alerts you want to receive.
Network Menu - Projector Control Menu
Settings on the Projector Control menu let you select settings for controlling
the projector over a network.
Setting Options Description
PJLink On
Off
Set to On to enable the PJLink
notification function.
PJLink Password Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
Enter a password for using the PJLink
protocol for projector control.
Notified IP Address Various IP
addresses
Enter the IP address to receive the
projector's operating status when the
PJLink notification function is enabled.
Enter the addresses using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
SNMP On
Off
Set to On to monitor the projector using
SNMP. To monitor the projector, you
need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
