Preparing Before Using Interactive Features
96
This section provides safety instructions on setting up and using the
interactive pens or performing touch operations with your finger. Read these
instructions before using the interactive features.
gg Related Links
• "Safety Instructions for Interactive Features" p.96
• "Using the Interactive Pens" p.96
• "Using Interactive Touch Operations with Your Finger" p.98
Safety Instructions for Interactive Features
The interactive feature operates by infrared communication. Note the
following important points when using this feature.
• Make sure there is no strong light or sunlight shining on the interactive pen
receiver and the projection screen.
• If there is any dust stuck to the interactive pen receiver, it could interfere
with infrared communication and you may not be able to use the features
normally. Clean the receiver if it is dirty.
• Do not put paint or any stickers on the cover of the interactive pen receiver.
• Do not use an infrared remote control or infrared microphone in the same
room because the interactive pen may malfunction.
• Do not use devices that generate powerful noise, such as rotary devices or
transformers, near the projector. You may not be able to operate the
interactive features.
Using the Interactive Pens
Before using the interactive pens, set up the system and calibrate the pens. See
your projector's Installation Guide for instructions.
a
You need to calibrate the system again if you notice any discrepancy in
positioning after doing any of the following:
• Performing Geometry Correction
• Adjusting the image size
• Using the Image Shift feature
• Changing the projector position
Your projector comes with a blue pen and an orange pen, identified by the
color on the end of the pen. You can use either pen, or both at the same time
(one of each color).
Make sure the pen batteries are installed.
A
Pen tip
B
Battery indicator
C
Button
D
Strap attachment point
E
Battery cover
To Next Page
Loading...
Need help?
General
Weight and Dimensions
