116 Managing Projectors
5. Do one of the following:
■ If your network assigns addresses automatically, turn on the
DHCP setting.
■ If your network does not assign addresses automatically, turn
off
DHCP and enter the projector’s IP Address, Subnet
Mask
, and Gateway Address.
To enter numbers, use the pointer button on the remote
control to highlight the number you want to input, then press
Enter.
6. When you’re done making all necessary changes, select
Return,
Setup complete, and then Yes to confirm that you want to save
the changes. Press
Menu to exit.
Using Projector E-mail Alerts
When this feature is enabled, the projector sends you an e-mail alert if
it has any problems.
PowerLite Pro G5150NL and G5350NL
1. Press the Menu button on the remote control, select the
Network menu, then press Enter.
2. Choose
Network Configuration and press Enter.
note
If you’re a network
administrator, you can use
the SNMP option to enter a
trap IP address. This lets you
receive trap alerts for the
rojectors you’re monitoring.
note
You can also set e-mail alerts
from EMP Monitor (see the
EMP Monitor Operation
Guide for more
information).
To Next Page
Loading...
Need help?
General
