152 Projector Installation
To remove the cover (when connecting or disconnecting cables),
loosen the screws on the bottom of the cover, pull the bottom of the
cover away from the projector as shown.
Installing and Removing the Lens
Installing the Lens
1. Turn off the projector and unplug the power cord.
2. Turn the focus ring clockwise until it stops moving.
note
Only install or remove the
lens when necessary. If dust
enters the projector,
projection quality may
deteriorate and/or the
projector may malfunction.
Do not install or remove the
lens when the projector’s lens
insertion section is facing
up. Dust could enter the
projector.
Do not touch the lens with
your hand or fingers. If
fingerprints or oils are left
on the surface of the lens,
projection quality will
deteriorate.
To Next Page
Loading...
Need help?
General
