20 Setting Up the Projector
Connecting to the Computer Port
You can connect to the projector using the VGA computer cable that
came with it (the monitor port on your computer must be a mini
D-sub 15-pin port).
1. If you’re using the VGA computer cable, connect one end to the
projector’s
Computer1 or Computer 2 port, and the other end
to your computer’s monitor port.
2. You may need to change the Input Signal setting in the
projector’s Signal menu to
RGB (see page 99).
3. You can connect an optional stereo mini-jack audio cable to play
sound through the projector (see page 32). With the optional
wireless mouse receiver (see page 56), you can use the remote
control as a mouse.
4. When you’ve finished making any connections, see page 37 for
instructions on turning on the projector and Chapter 2 for
instructions on displaying and adjusting the image.
caution
Don’t try to force a
connector to fit a port with a
different shape or number of
pins. You may damage the
port or connector.
To Next Page
Loading...
Need help?
General
