Setting Up the Projector 29
Connecting an RGB Video Source
Connecting Using a VGA Computer Cable
1. Locate the VGA computer cable provided with the projector.
2. Connect the cable to the video port on your player and
the
Computer1 or Computer2 port on the projector.
3. You may need to change the
Input Signal setting in the
projector’s Signal menu to
RGB (see page 99).
4. If you want to play sound through the projector, see page 32 for
instructions on connecting audio cables.
5. If you don’t need to make any other connections, see page 37 for
instructions on turning on the projector and Chapter 2 for
instructions on displaying and adjusting the image.
note
Be sure your video player is
not a component video
source. If you select the
wrong source, image quality
may suffer. Check your
video player’s
documentation.
To Next Page
Loading...
Need help?
General
