36 Setting Up the Projector
Removing the USB Cable
If you’re using PC Free mode to project your images, exit PC Free
mode before you remove the USB device or cable from the projector.
1. Position the cursor over the
Exit button in the upper right corner
of the PC Free screen.
2. Press the
Enter button on the remote control to close PC Free
mode.
3. Turn off your digital camera or other device.
4. Disconnect the USB cable.
Inserting an SD Card
You can use an SD or SDHC (SD High Capacity) card to store
images, movies, and Scenario files. This lets you project your files
without connecting to a laptop or PC (G5150NL and G5350NL
only, see the EasyMP Operation Guide). To place your files on the
card, copy them from your computer to the card using a card reader.
1. Follow the instructions beginning on page 37 to turn on the
projector.
2. Insert the SD card face-up into the slot as shown:
Indicator
light
To Next Page
Loading...
Need help?
General
