Epson EB-G6170 User Manual

Status Cause Remedy or Status
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.96
Lamp Error
Lamp Failure
Check the following two points.
• Take out the lamp and check if it is cracked.
s "Replacing the Lamp" p.144
• Clean the air filter.
s "Cleaning the Air Filter" p.141
If the lamp is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s Epson Projector Contact List
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be
projected until the lamp is replaced.)
s Epson Projector Contact List
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.96
Auto Iris Error
Power Err. (Ballast)
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
Filter Airflow Error Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.141
s "Replacing the Air Filter" p.147
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Problem Solving
124

Epson EB-G6170 Specifications

General

Brand	Epson
Model	EB-G6170
Category	Projector
Language	English