• Lamp out
• Internal temperature error
• High-speed cooling in progress
• Lamp replacement notification
• Low Air Flow (Low Air Flow)
• Low Air Flow Error (Filter Airflow Error)
• No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
• Auto Iris Error
• Power Err. (Ballast)
See the following to deal with problems or warnings.
s "Reading the Indicators" p.122
Management Using SNMP
By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s Network - Administrator Settings - SNMP p.109
a
• SNMP should be managed by a network administrator or someone
who is familiar with the network.
• To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
• The SNMP Agent for this projector complies with version 1
(SNMPv1).
• The managing function using SNMP cannot be used over wireless
LAN in Quick connection mode.
• Up to two destination IP addresses can be saved.
Displaying the Web Remote Screen
The Web Remote function allows you to perform projector remote control
operations with a Web browser.
a
Display the Web Control screen.
b
Click Web Remote.
If Web Remote Password is set in the Network menu, enter
"EPSONREMOTE" into the user ID.
c
The Web Remote screen is displayed.
Monitoring and Controlling
164
To Next Page
Loading...
Need help?
General
