Check Remedy
Does Remote Control Type match the remote control that you are
using?
Check the Remote Control Type on the configuration menu.
s Extended - Operation - Remote Control Type p.96
Is the optional remote control cable connected to the projector's
Remote port?
When the remote control cable is connected, the projector's remote receiver is disabled. When not using the remote
control cable set, disconnect it from the Remote port.
Is Control Communications set to On? The Remote port is disabled. When using the optional remote control cable set, set Control Communications to
Off.
s Extended - HDBaseT - Control Communications p.96
Is the remote control button lock set? When the remote control button lock is set, buttons except for those needed for basic remote control operations are
deactivated. Hold down the [Help] button to cancel the remote control button lock.
s "Remote control button lock" p.86
Nothing appears on the external monitor
Check Remedy
Are images input from a port other than the Computer port or
BNC port?
Only RGB signals from the Computer port or the BNC port can be displayed on an external monitor.
Are you projecting a split screen? Only RGB signals projected on the left screen from the Computer port or the BNC port can be displayed on an
external monitor.
s "Projecting Two Images Simultaneously (Split Screen) " p.71
Is the projector in standby status? Check that Standby Mode, A/V Output, and Monitor Out from the Configuration menu are set correctly.
s Extended - Standby Mode p.96
s Extended - A/V Settings p.96
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the Language setting from the Configuration menu.
s Extended - Language p.96
Problem Solving
135
To Next Page
Loading...
Need help?
General
