To Next Page

To Previous Page

Replace the air filter.

Press until it clicks into place.

Close the air filter cover.

• If a message is frequently displayed, even after cleaning, it is time to

replace the air filter. Replace it with a new air filter.

s "Replacing the Air Filter" p.147

• It is recommended that you clean these parts at least once every

three months. Clean them more often than this if using the projector

in a particularly dusty environment.

• The indicators or messages regarding Air Filter Notice are displayed

only when Air Filter Notice is set to On from the Configuration

menu.

s Extended - Display - Air Filter Notice p.96

Cleaning

143

Notations Used in this Guide2
- Table of Contents8
Introduction12
Part Names and Functions13
- Front/Top13
- Rear14
- Interface15
- Base16
- Control Panel16
- Remote Control18
  - Replacing the Remote Control Batteries20
  - Remote Control Operating Range22
Preparing the Projector23
Installing the Projector24
- Removing and Attaching the Projector Lens Unit24
  - Attaching24
  - Removing25
- Installation Settings26
  - Setting the Direction26
  - Changing the Direction of the Image (Projection Mode)27
- Screen Settings27
  - Adjusting the Position of the Image on the Projected Screen28
- Displaying a Test Pattern29
- Adjusting the Position of the Projected Image (Lens Shift)30
- Adjusting the Image Size32
- Correcting the Focus32
  - When Using the Short Throw Zoom Lens ELPLU0132
- Adjusting the Height of the Projected Image (for Normal Installment)33
- Adjusting the Horizontal Tilt (for Normal Installment)33
- ID Settings34
- Setting the Time35
- Other Settings37
  - Settings Related to Basic Operations37
  - Settings Related to Display38
Connecting Equipment39
- Connecting a Computer39
- Connecting Image Sources41
- Connecting External Equipment43
- Connecting a LAN Cable44
- Connecting an Hdbaset Transmitter44
- Installing the Wireless LAN Unit46
- Attaching the Cable Cover47
  - Attaching47
Basic Usage48
Projecting Images49
- Automatically Detect Input Signals and Change the Projected Image (Source Search)49
- Switching to the Target Image by Remote Control50
- Adjusting the Volume50
Adjusting Projected Images51
- Correcting Distortion in the Projected Image51
- Selecting the Projection Quality (Selecting Color Mode)56
- Setting Auto Iris57
- Changing the Aspect Ratio of the Projected Image57
  - Changing Methods57
- Adjusting the Image60
Contents62
- Projecting 3D Images62
Useful Functions64
Multi-Projection Function65
- Preparation65
- Adjust the Edges of the Images (Edge Blending)66
  - Adjusting the Brightness of the Lamp66
  - Performing Edge Blending66
- Adjusting to Match Colors68
- Scaling an Image (Scale)69
Projection Functions71
- Projecting Two Images Simultaneously (Split Screen)71
  - Operating Procedures71
  - Restrictions During Split Screen Projection73
- Hiding the Image and Sound Temporarily (A/V Mute)74
- Freezing the Image (Freeze)75
- Enlarging Part of the Image (E-Zoom)75
- Saving a User's Logo76
Memory Function78
- Saving/Loading/Erasing the Memory78
Scheduling Function80
- Saving a Schedule80
  - Setting Methods80
  - Editing a Schedule81
Security Functions83
- Managing Users (Password Protection)83
- Restricting Operation85
  - Control Panel Lock85
  - Remote Control Button Lock86
- Anti-Theft Lock86
  - Installing the Wire Lock87
Configuration Menu88
Using the Configuration Menu89
List of Functions90
- Configuration Menu Table90
  - Network Menu91
- Image Menu92
- Signal Menu93
- Settings Menu95
- Extended Menu96
- Network Menu100
- Info Menu (Display Only)113
- Reset Menu114
Batch Setup115
- Setup Using a USB Flash Drive115
  - Saving Settings to the USB Flash Drive115
  - Reflecting Saved Settings to Other Projectors117
- When Setup Fails119
Contents120
Troubleshooting120
Using the Help121
Problem Solving122
- Reading the Indicators122
- When the Indicators Provide no Help126
- Problems Relating to Images127
- Problems When Projection Starts132
  - The Projector Does Not Turn on132
- Other Problems133
About Event ID138
Maintenance140
Cleaning141
- Cleaning the Projector's Surface141
- Cleaning the Lens141
- Cleaning the Air Filter141
Replacing Consumables144
- Replacing the Lamp144
- Replacing the Air Filter147
  - Air Filter Replacement Period147
  - How to Replace the Air Filter147
Image Maintenance149
- Panel Alignment149
- Color Uniformity150
- Adjusting the Lens Balance152
Appendix156
Network Functions157
- Projecting with "Connect to a Network Projector157
- Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point157
  - Connection Setup Method157
- Using the Quick Wireless Connection USB Key158
Monitoring and Controlling160
- About Easymp Monitor160
  - About Message Broadcasting160
- Changing Settings Using a Web Browser (Web Control)160
Contents163
- Using the Mail Notification Function to Report Problems163
  - Reading Error Notification Mail163
- Management Using SNMP164
- Displaying the Web Remote Screen164
- ESC/VP21 Commands165
  - Command List165
  - Cable Layouts166
- About Pjlink167
- About Crestron Roomview167
  - Operating a Projector from Your Computer168
Optional Accessories and Consumables172
- Optional Accessories172
- Consumables173
Screen Size and Projection Distance174
- Projection Distance (for EB-G6770WU/EB-G6570WU/EB-G6470WU/EB-G6270W/EB- G6070W)174
- Projection Distance (for EB-G6370/EB-G6170)179
Supported Monitor Displays185
- Supported Resolutions185
- Input Signal from the HDMI Port , Displayport, and Hdbaset *1186
  - Input Signal from the HDMI Port , Displayport, and Hdbaset Port186
Specifications187
- Projector General Specifications187
Appearance191
Glossary192
General Notes194
- About Notations194
- Trademarks and Copyrights195
Index196

Brand	Epson
Model	EB-G6170
Category	Projector
Language	English

Epson EB-G6170 User Manual

Table of Contents

Other manuals for Epson EB-G6170

Questions and Answers:

Epson EB-G6170 Specifications

Related product manuals