To Next Page

To Previous Page

The following color modes are available when projecting 3D images. When

projecting using the optional polarizers (ELPPL01), you can view images at

their optimal color tint.

• 3D Dynamic

• 3D Presentation

• 3D Theatre

• 3D Multi-Projection

This projector arranges the direction of polarizing projection for R

(red), G (green), and B (blue). It is not necessary to inverse left and

right eye G (green) image signals.

Adjusting Projected Images

Notations Used in this Guide2
- Table of Contents8
Introduction12
Part Names and Functions13
- Front/Top13
- Rear14
- Interface15
- Base16
- Control Panel16
- Remote Control18
  - Replacing the Remote Control Batteries20
  - Remote Control Operating Range22
Preparing the Projector23
Installing the Projector24
- Removing and Attaching the Projector Lens Unit24
  - Attaching24
  - Removing25
- Installation Settings26
  - Setting the Direction26
  - Changing the Direction of the Image (Projection Mode)27
- Screen Settings27
  - Adjusting the Position of the Image on the Projected Screen28
- Displaying a Test Pattern29
- Adjusting the Position of the Projected Image (Lens Shift)30
- Adjusting the Image Size32
- Correcting the Focus32
  - When Using the Short Throw Zoom Lens ELPLU0132
- Adjusting the Height of the Projected Image (for Normal Installment)33
- Adjusting the Horizontal Tilt (for Normal Installment)33
- ID Settings34
- Setting the Time35
- Other Settings37
  - Settings Related to Basic Operations37
  - Settings Related to Display38
Connecting Equipment39
- Connecting a Computer39
- Connecting Image Sources41
- Connecting External Equipment43
- Connecting a LAN Cable44
- Connecting an Hdbaset Transmitter44
- Installing the Wireless LAN Unit46
- Attaching the Cable Cover47
  - Attaching47
Basic Usage48
Projecting Images49
- Automatically Detect Input Signals and Change the Projected Image (Source Search)49
- Switching to the Target Image by Remote Control50
- Adjusting the Volume50
Adjusting Projected Images51
- Correcting Distortion in the Projected Image51
- Selecting the Projection Quality (Selecting Color Mode)56
- Setting Auto Iris57
- Changing the Aspect Ratio of the Projected Image57
  - Changing Methods57
- Adjusting the Image60
Contents62
- Projecting 3D Images62
Useful Functions64
Multi-Projection Function65
- Preparation65
- Adjust the Edges of the Images (Edge Blending)66
  - Adjusting the Brightness of the Lamp66
  - Performing Edge Blending66
- Adjusting to Match Colors68
- Scaling an Image (Scale)69
Projection Functions71
- Projecting Two Images Simultaneously (Split Screen)71
  - Operating Procedures71
  - Restrictions During Split Screen Projection73
- Hiding the Image and Sound Temporarily (A/V Mute)74
- Freezing the Image (Freeze)75
- Enlarging Part of the Image (E-Zoom)75
- Saving a User's Logo76
Memory Function78
- Saving/Loading/Erasing the Memory78
Scheduling Function80
- Saving a Schedule80
  - Setting Methods80
  - Editing a Schedule81
Security Functions83
- Managing Users (Password Protection)83
- Restricting Operation85
  - Control Panel Lock85
  - Remote Control Button Lock86
- Anti-Theft Lock86
  - Installing the Wire Lock87
Configuration Menu88
Using the Configuration Menu89
List of Functions90
- Configuration Menu Table90
  - Network Menu91
- Image Menu92
- Signal Menu93
- Settings Menu95
- Extended Menu96
- Network Menu100
- Info Menu (Display Only)113
- Reset Menu114
Batch Setup115
- Setup Using a USB Flash Drive115
  - Saving Settings to the USB Flash Drive115
  - Reflecting Saved Settings to Other Projectors117
- When Setup Fails119
Contents120
Troubleshooting120
Using the Help121
Problem Solving122
- Reading the Indicators122
- When the Indicators Provide no Help126
- Problems Relating to Images127
- Problems When Projection Starts132
  - The Projector Does Not Turn on132
- Other Problems133
About Event ID138
Maintenance140
Cleaning141
- Cleaning the Projector's Surface141
- Cleaning the Lens141
- Cleaning the Air Filter141
Replacing Consumables144
- Replacing the Lamp144
- Replacing the Air Filter147
  - Air Filter Replacement Period147
  - How to Replace the Air Filter147
Image Maintenance149
- Panel Alignment149
- Color Uniformity150
- Adjusting the Lens Balance152
Appendix156
Network Functions157
- Projecting with "Connect to a Network Projector157
- Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point157
  - Connection Setup Method157
- Using the Quick Wireless Connection USB Key158
Monitoring and Controlling160
- About Easymp Monitor160
  - About Message Broadcasting160
- Changing Settings Using a Web Browser (Web Control)160
Contents163
- Using the Mail Notification Function to Report Problems163
  - Reading Error Notification Mail163
- Management Using SNMP164
- Displaying the Web Remote Screen164
- ESC/VP21 Commands165
  - Command List165
  - Cable Layouts166
- About Pjlink167
- About Crestron Roomview167
  - Operating a Projector from Your Computer168
Optional Accessories and Consumables172
- Optional Accessories172
- Consumables173
Screen Size and Projection Distance174
- Projection Distance (for EB-G6770WU/EB-G6570WU/EB-G6470WU/EB-G6270W/EB- G6070W)174
- Projection Distance (for EB-G6370/EB-G6170)179
Supported Monitor Displays185
- Supported Resolutions185
- Input Signal from the HDMI Port , Displayport, and Hdbaset *1186
  - Input Signal from the HDMI Port , Displayport, and Hdbaset Port186
Specifications187
- Projector General Specifications187
Appearance191
Glossary192
General Notes194
- About Notations194
- Trademarks and Copyrights195
Index196

Brand	Epson
Model	EB-G6170
Category	Projector
Language	English

Epson EB-G6170 User Manual

Table of Contents

Other manuals for Epson EB-G6170

Questions and Answers:

Epson EB-G6170 Specifications

Related product manuals