Epson ES-580W

Connecting the Scanner to the Network
If the scanner is not connected to the network, use the installer to connect the scanner to the network.
You can use any of the following methods to start the installer.
❏ Setting up from the website
Access the following website, and then enter the product name. Go to Setup, and then start setting up.
http://epson.sn
❏ Setting up using the soware disc (only for models that come with a soware disc and users with Windows
computers with disc drives.)
Insert the soware disc into the computer, and then follow the on-screen instructions.
If you want to check the network connection or connect to the network manually, see the related information.
Related Information
& “Checking the Network Connection Status” on page 183
& “Connect the Scanner to the Network Manually” on page 187
Conguring a Mail Server
Set the mail server from Web Cong.
When the scanner can send the email by setting the mail server, the following are possible.
❏ Transfers the scan results by using email
❏ Receives the email notication from the scanner
Check below before setting up.
❏ e scanner is connected to the network that can access the mail server.
❏ Email setting information of the computer that uses the same mail server as the scanner.
Note:
❏ When you use the mail server on the Internet, conrm the setting information from the provider or website.
❏ You can also set the mail server from the control panel. Access as below.
Settings > Network Settings > Advanced > Email Server > Server Settings
1.
Access Web Cong and select the Network tab > Email Server > Basic.
2.
Enter a value for each item.
3.
Select OK.
e settings you have selected are displayed.
When the setup completes, perform the connection check.
Related Information
& “Running Web Cong on a Web Browser” on page 26
Preparing to Scan over a Network > Conguring a Mail Server
66