123
2. Insert the SD card into the projector's card slot.
Note: Insert the SD card directly into the projector. Do not use a hub or your settings may not be
saved correctly.
3. Press and hold the Esc button on the remote control as you connect the power cord to the
projector's power inlet.
4. When the On/Standby and Status lights are blue, and the Laser and Temp lights are orange, release
the Esc button.
The lights flash as settings transfer to the SD card. When the lights stop flashing, the On/Standby
light turns blue and the projector enters standby mode.
Caution: Do not unplug the power cord or remove the SD card while the lights are flashing. This
could damage the projector.
5. Once the projector enters standby mode, remove the SD card.
Parent topic: Copying Menu Settings Between Projectors
To Next Page
Loading...
Need help?
General
