164
• Make sure you have access to the network the projector is on.
• Make sure you enter the projector's IP address in the web browser address bar.
Note: The user ID and password are case sensitive.
Parent topic: Solving Network Problems
Related references
Projector Network Settings - Network Menu
Solutions When You Cannot Access the SD Card Through the Web
If you are unable to access the SD card through a web browser, try the following solutions:
• Make sure the SD card is inserted correctly.
• Make sure the SD card is not write-protected.
• Make sure you use an SDHC card of Class 10 or higher with a maximum capacity of 32GB, or an SD
card formatted in FAT16 or FAT32.
Parent topic: Solving Network Problems
Related tasks
Inserting an SD Card
Controlling a Networked Projector Using a Web Browser
Solutions When Network Alert E-Mails are Not Received
If you do not receive an e-mail alerting you to problems with a projector over the network, try the
following solutions:
• Make sure the projector is turned on and connected to the network correctly. (If an error shut down the
projector, it cannot send an e-mail.)
• Make sure your electrical outlet or power source is functioning properly.
• Make sure you set up the projector e-mail alert settings correctly on the projector's network menu or in
the network software.
• Set the Standby Mode setting to Communication On so the network software can monitor the
projector in standby mode. Change the Port setting according to your network environment.
Parent topic: Solving Network Problems
To Next Page
Loading...
Need help?
General
