132
The following settings will not transfer between projectors:
• Network menu settings other than those in the Notifications and Others menus
The following settings will not transfer between projectors if you set the Batch Setup Range setting to
Limited:
• Password Protection settings
• Network menu settings other than those in the Notifications and Others menus
Note: In addition to the methods covered in this section, you can also copy and transfer settings to
multiple projectors over a network using the Epson Projector Management software. See the online
Epson Projector Management Operation Guide for instructions. You can download the latest software
and documentation from the Epson website.
Saving Settings to an SD Card
Transferring Settings from an SD Card
Parent topic: Adjusting Projector Features
Related references
Additional Projector Software and Manuals
Saving Settings to an SD Card
You can save the projector settings you want to transfer to an SD card.
Note: Use an empty SD card. If the card contains other files, the transfer may not complete correctly.
The SD card cannot have any security features and must be an SDHC card of Class 10 or higher with a
maximum capacity of 32GB, or an SD card formatted in FAT16 or FAT32.
1. Turn off the projector and unplug the power cord from the projector's power inlet.
To Next Page
Loading...
Need help?
General
