181
• Check the Event ID number displayed in the Info menu and check the link below to identify the
problem.
• If the access point security is WPA3-EAP, change the access point setting to WPA2/WPA3-EAP.
Parent topic: Solving Network Problems
Related references
Projector Network Settings - Network Menu
Event ID Code List
Solutions When You Cannot Access the Projector Through the Web
If you are unable to access the projector through a web browser, make sure you are using the correct ID
and password, which are case sensitive.
• For the user ID, enter EPSONWEB. (You cannot change the user ID.)
• For the password, enter the password set in the projector's Network menu. The default password is
admin.
• Make sure you have access to the network the projector is on.
• Make sure you enter the projector's IP address in the web browser address bar and your device is on
the same network.
• If your Web browser is set up to connect via a proxy server, the Epson Web Control screen cannot
be displayed. Make settings for a connection without using a proxy server.
• If you set Standby Mode to Communication On in the projector's menu in standby mode, make sure
the network device is turned on. After turning on the network device, turn on the projector. Connect to
a wired LAN, or to a wireless LAN with the Connection Mode setting set to Advanced.
Note: The user ID and password are case sensitive.
Parent topic: Solving Network Problems
Related references
Projector Network Settings - Network Menu
Solutions When You Cannot Access the SD Card Through the Web
If you are unable to access the SD card through a web browser, try the following solutions:
• Make sure your device is on the same network as the projector.
• Make sure the SD card is inserted correctly.
To Next Page
Loading...
Need help?
General
