39
Inserting an SD Card
Insert a commercially available SD card into the projector's SD card slot.
Note: An SD card is required to project from a playlist created using the Epson Projector Content
Manager software.
Make sure you use an SDHC card of Class 10 or higher with a maximum capacity of 32GB, or an SD
card formatted in FAT16 or FAT32.
Parent topic: Setting Up the Projector
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector. Replace the batteries as soon
as they run out.
Caution: Use only the type of batteries specified in this manual. Do not install batteries of different types,
or mix new and old batteries.
1. Remove the battery cover.
To Next Page
Loading...
